The Splash Aquatic Lift is a semi-portable lifting system designed for swimming facilities seeking to provide user friendly access to their swimming pools. A lifting capacity of 181 kg for the Standard lift and 136 kg for the Extended Reach.The Splash is a 24v battery powered and operated by a screw driven actuator. It features full mechanised left and right as well as up and down motion. The design and durability of the system ensures consistent operation and minimises service problems.

The Splash is virtually maintenance free. The components are made from corrosion resistant materials, including powder coated stainless steel and aluminium construction. The unique seat of the lift was specifically designed to provide the user with the greatest possible safety, comfort and ease of transfer.

The hand control is completely waterproof, and allows either the user or the attendant to control its operation with ease. The LiftOperator control box and battery are water resistant and should be protected from long exposure to the water. A small, waterproof cover is included with each lift to cover the LiftOperator control box when the system is in use. If the lift is used outdoors, an optional full cover is available for purchase and is recommended to use to protect the system.

The seating system used is the product of years research.  The seat itself is both deeper and higher to both provide a more stable platform for sitting, as well as being able to better accommodate swimmers with reduced trunk stability. The seat has been flattened considerably to eliminate any ridge that would hamper transferring. The sections of the seat have attachment points for both the standard seat belt assembly as well as an optional stability vest.

The standard, moulded plastic footrest is removable and will float upwards to prevent damage if the user lowers the chair too low over the deck.

The included armrests have been strengthened which allows them to be used for support when transferring onto the seat. They can be rotated out of the way during a transfer and can now be added to a seat after the fact, without the need to purchase an entire new seat assembly.

A sling option is also available. The sling can be used instead of the seat by undoing two bolts and removing the arm and seat assembly and replacing it with the Sling Jib. The Sling is then attached to the sling jib. The sling and Jib can be retrofitted to existing Splash, Pal and Pal2 lifts. 

What's included:
Splash! Lift, Deck Anchor, Footrest, Caddie, Arm Rests, Battery Charger, Battery Cover and Seat Belt Assembly.

Operation:
The client accesses the lift seat then using the left and right buttons on the hand controller rotates the lift over the pool then using the up or down button to raise or lower the seat. The client can then be floated off the seat. Getting out is just as simple.

Installation:
The typical installation usually is attached to the pool deck using a square deck anchor that will be cored into the pool deck.

Optional Extras:
Sling and Jib Attachment
Use instead of the seat to lift and lower.

Spine Board Attachment
The Spine Board Attachment works with any standard spine board (not included). Simply remove the chair assembly by pulling the attachment pin and replace that assembly with the Spine Board Attachment. One person can easily extract an injured swimmer from a pool.

Total Cover
Use the cover to protect your investment when not in use.

Spine Board Attachment
The Spine Board Attachment works with any standard spine board (not included). Simply remove the chair assembly by pulling the attachment pin and replace that assembly with the Spine Board Attachment. One person can easily extract an injured swimmer from a pool.

The Splash! Lift is available in two configurations:
Splash Standard - Suits most applications. (Max. 700mm from water at water level) 
Splash Extended Reach - For pools requiring a longer reach.

Shipping Dimensions:
Standard - 102 x 122 x 152cm (L x W x H) 127kg
E/R - 102 x 122 x 198cm (L x W x H) 152kg